Comrades in Arms Discussion Board

Hi,

I have all other addons installed except BAS, i put it to the right folder with mod parameter and always when i launch it i get the following message:

Cannot create 3D device:
Adapter 0 (ATI radeon HD4870 X2) Fullscreen
Resolution 1360x768, format X8R8G8B8/D24S8, refresh 60 Hz.
Error D3DERR_NOTAVAILABLE

if i disable @BAS from parameter it works fine.

EDIT: Works now. See below for solution.

That's not really a a BAS problem, it's a GFX problem. Try reset your GFX settings (or lower them) and start with BAS. Then you can adjust your GFX settings again.

I have tryed to change my GFX settings already and i still keep getting the same error, and just to clarify i have also tryed to change resolution.

Normally i would use 1920 x 1200, but its in repair service so i have to use TV monitor.
Havent had before these problems.

Hey Make,

A couple of things to try;

Run FlashpointPreferrences.exe. Look in the Display box and make sure you see your video card shown and also that is is set for
Direct3D HW T&L. It should look like this:


Then go to your Windows start button and select "RUN". In the box type dxdiag and click "OK".
Then allow the DirectX diagnostic program to run. This should fix your problem.

Hi Zulu,

I tryed that out.
Seems like i still get the same error message,
i will try to reinstall OFP today and see if it works,
if not then i just have to wait until i get my old monitor  back... i guess  :

Turn off HW T&L and use -nomap

I actually solved my problem by installing BAS from different  site (strange).
Thanks for everyone who tryed to help