Comrades in Arms Discussion Board

Hello all,

I am searching for some scripts or addons that allow the player to command a pilot squad member to adjust his helicopter flying altitude i.e. for boarding, extraction, injection, high flight, landing.

I know that I have stumbled around such a thing in ECP CTI once, but I am not sure. However, I do remember that there is no such a thing in WGL. Or am I wrong?

Cheers,

Wuschel

If the pilot is in commaders group it's done by action menu or direct order I think.

The flyinheight command will probably be part of your solution.

http://www.ofpec.com/COMREF/index.php?ac...ils&id=137

Note the information in the comments section, too.

Try this one:

http://www.ofpec.com/ed_depot/index.php?...6&game=OFP

Works fine in MP dedicated server too; we've tested it

Thanks!

I creached around and also found some intersting commands in the official Action List of OPF.

It's one of the ECP 1.085 features.

Hi,

yes, indeed the ECP scripts are excellent. Too bad that they are not availible in WGL. I have asked this question in the Bohemia Interactive Forums, but it seems to me that the general level of activity is too low to get an good response in a reasonable amount of time:

Is it possible to adopt the BAS helicopter command scripts from the ECP mod(flying height, extraction, rapid insertion, landing) in any way for WGL? It does not have to be a 1:1 conversion, a simple land without switching off the engine and let all marked units disembark the transport helicopter would be enough.

Or are these scripts specifically designed for the ECP mod? I had a look at them, however, and it seemed to me that a lot of ECP dependent command were included.

Regards,

wuschel