09-18-2014, 11:30 AM
I've been trying again, and I can basically load any sketch from the Arduino IDE and run that (tested some of the string tests with serial monitor enabled).
But as soon as I disconnect the device and reconnect, it won't work anymore. It won't even find the COM port. This can sometimes be fixed with reconnecting.
However, EdTracker doesn't want to flash or connect... and most of the time, using FreeTrackNoIR and an older sketch from the BI thread doesn't work either (freetrack doesn't show any movement).
Frustrating...
But as soon as I disconnect the device and reconnect, it won't work anymore. It won't even find the COM port. This can sometimes be fixed with reconnecting.
However, EdTracker doesn't want to flash or connect... and most of the time, using FreeTrackNoIR and an older sketch from the BI thread doesn't work either (freetrack doesn't show any movement).
Frustrating...