09-18-2014, 08:08 PM
(09-18-2014, 07:57 PM)doveman link Wrote: Varanon, I've wired up my Pro Micro/MPU now and using the Headtracker calibration GUI, I can calibrate it fine but when I then flash it with the full firmware, the GUI can no longer connect with it. The COM port is still visible to the PC and the app, so something else is wrong. I even tried an older firmware as the GUI lets you choose from a couple and that was the same.
Same here. I worked around this by using the command line tool to flash it, and then start the GUI and this works
However, I lack input from one axis... might need to re-check the cables, or replace the 6050