09-19-2014, 09:42 AM
(09-18-2014, 08:08 PM)Varanon link Wrote: Same here. I worked around this by using the command line tool to flash it, and then start the GUI and this works
However, I lack input from one axis... might need to re-check the cables, or replace the 6050
I tried flashing it with the command line but I still just get "Error for connecting to COM12" in the GUI. As I say, it works fine with the Calib firmware flashed.
Anyway, I'm going to concentrate on my GY-85 build, as I think the MPU still has issues with drift. If you do think your MPU is faulty, I'd recommended getting a GY-85 instead of another MPU, as the magnetometer allows for cancelling out any drift automatically.
Having said that, the code still needs some work to iron out some issues but it is being worked on by a couple of people. If you can put up with the drift, then you might prefer to stick with the more polished EDtracker MPU software, which might have less issues than the GY-85 code at the moment (but I can't compare them as I can't get it to work myself).